2015 Ram 2500 Front Axle U Joint Replacement

The front axle U joint on a 2015 Ram 2500 needs to be replaced when it becomes worn or damaged. To replace the U joint, you’ll need to first disconnect the brake lines and drive shaft from the axle housing. Next, unbolt the two bolts that hold the u-joint in place on either side of the axle.

After removing those bolts, carefully slide out the old u-joint and put aside. Now take your new u-joint and install it into place in a similar fashion as how you removed it earlier by sliding it into position before bolting both sides down tightly with new hardware where necessary. Once everything is secure, reattach all brakes lines/shafts back onto their respective places then torque down any related hardware for added security before testing out your hard work!

Replacing the front axle u-joints on a 2015 Ram 2500 is an essential part of regular maintenance, and can help keep your truck running reliably for years to come. Replacing these u-joints is relatively simple, as long as you have all the necessary tools and parts on hand. With just a few basic steps, such as removing the old joint and installing the new one with greaseable bolts or other fasteners, you can ensure that your truck’s front axle will be in good condition for many miles to come!

2013-2018 Ram 2500 Axle U-Joint Replacement Part 1

How Much Does It Cost to Replace a Front Axle U-Joint?

The cost to replace a front axle u-joint varies depending on the make and model of your vehicle, as well as where you are buying the part. Generally speaking, a new u-joint can range anywhere from $20-$100. Labor costs will also vary based on the type of work that needs to be done, but typically hover around $50-$150 an hour at most repair shops.

It is important to note that when replacing a u-joint it may be necessary to also replace other parts such as drive shafts or yokes in order for everything to line up properly – this could add significantly more labor and parts costs onto your overall bill. If you are considering replacing your front axle u-joint yourself, all the necessary tools should run about another $30-$50 dollars – so factor these into your budget if you decide to go down this route. All in all, expect total replacement costs for a front end axle joint (including labor) between roughly $100-$400 depending on what kind of car you have and how much work is required by the mechanic who handles it.

How Do You Know If Your U-Joint is Bad on a Ram 2500?

If you own a Ram 2500, it’s important to keep an eye out for signs that your u-joint may be failing. If not addressed in a timely manner, this can lead to further damage and expensive repairs down the road. Symptoms of a failing u-joint include clunking or grinding noises when driving over bumps or accelerating/decelerating; interference with smooth acceleration; vibration from the drive shaft; and loose steering.

In some cases, you might even notice smoke coming from underneath your vehicle if the joint is completely destroyed. Additionally, you should also make sure to regularly inspect your differential fluid levels as low levels could indicate wear on one or more of the universal joints within the system. Finally, if any of these symptoms begin presenting themselves or appear worse than usual after inspection then it may be time to have your u-joint replaced before further damage occurs!

What are the Symptoms of a Bad Front Axle U-Joint?

A bad front axle u-joint can cause several issues in your vehicle, leading to a dangerous and uncomfortable ride. The most noticeable symptom of a bad front axle u-joint is an unusual clunking or clicking noise coming from the area around the tire while driving. You may also notice that your steering wheel shakes or vibrates at certain speeds, especially when accelerating or decelerating.

Additionally, you may experience difficulty turning corners on uneven surfaces due to increased resistance in the joints. Other signs include excessive wear on tires, suspension components, and other parts of the car being affected by the misalignment caused by a faulty front axle u-joint. If you believe one of your u-joints needs replacing it is important to have it checked out as soon as possible; otherwise there’s no telling what kind of damage could result from continued use with a faulty part!

What Size is the Front Axle Nut on a 2015 Dodge Ram 2500?

The front axle nut size on a 2015 Dodge Ram 2500 is M22 x 1.5 RH. This means that the threads are 22 millimeters in diameter and have a pitch of 1.5 millimeters per thread, with right hand (RH) threads. It is important to use the correct sized socket when replacing or tightening this nut as using one that’s too small can cause it to round off and become stuck, while using one that’s too large can damage the threads making it difficult for the nut to hold properly.

Additionally, some aftermarket wheels may require different nuts than those used on factory-installed models so be sure to check before purchasing any replacement parts for your Dodge Ram 2500!

2015 Ram 2500 Front Axle U Joint Replacement

Credit: www.dieseltruckresource.com

Dodge Ram 2500 Front Axle U-Joint Replacement Cost

Replacing the U-joints on a Dodge Ram 2500’s front axle can be an expensive repair. Depending on the severity of the damage, replacing just one or both U-joints and their components can cost anywhere from $150 to $1,000+. It is important to have all three components (U-Joint, Yoke and Cross) inspected regularly in order to prevent any major repairs down the line.

2016 Ram 2500 Front Axle U Joint Replacement

Replacing the front axle U joint on a 2016 Ram 2500 is an important part of routine maintenance. The procedure requires removal of the driveshaft, which can be done with basic hand tools and some patience. Once removed, you will need to replace the old U joint with a new one.

Make sure that you purchase a quality replacement part as this is a critical component for safe operation of your truck.

2014 Ram 2500 Front Axle U Joint Replacement

Replacing the front axle u-joints on a 2014 Ram 2500 is an essential part of maintaining your vehicle. The u-joints are responsible for transferring power from the transmission to the wheels, and should be checked regularly for wear and tear. If you notice any play in your u-joints or if they make unusual noises when turning, it’s time to replace them.

Fortunately, replacing the front axle u-joints on a 2014 Ram 2500 is not too difficult with basic automotive knowledge and tools. It will require removing some components such as the drive shaft and brake calipers before you can access the old joints, but once that’s done only a few fasteners need to be removed before installation of new parts can commence.


This blog post has provided a great guide to replacing the front axle U joint on a 2015 Ram 2500. It is important to keep up with regular maintenance of your vehicle and this repair project can be completed at home if you have the right tools and parts. With detailed instructions, photos, and helpful tips along the way, anyone can feel confident in their ability to complete this job successfully.


  • Zayn

    John Zayn Smith is a renowned truck enthusiast, automotive industry expert, and author. Beginning his career as a mechanic, Zayn's curiosity led him to explore all facets of the trucking world, sharing his insights through in-depth articles on TruckGuider.com. His knowledge spans truck mechanics, trends, and aftermarket modifications, making him a trusted resource for both professionals and hobbyists. Outside writing and mechanics, Zayn enjoys off-roading, truck shows, and family time. Follow his work for the latest in truck-related news and tips.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *