The oil filter on the 2016 Ram 1500 is located in the engine bay, near the rear of the motor. It should be easy to spot as it has a round shape and has an attached cap with some text printed on it. To access and change this filter, you must first open the hood of your truck and locate the filter itself.

Once found, use a wrench or socket set to loosen and remove its retaining nut before sliding out the old filter. Replace it with a new one (using either oil-resistant gloves or disposable rags) then reinstall all components back into place before closing up your vehicle’s hood.

The oil filter on the 2016 Ram 1500 is located in the engine bay, beneath the air box. It can be accessed from underneath the vehicle or from a panel behind the driver side headlight. To replace it, you’ll need to unscrew and remove the old oil filter before installing the new one with an appropriate amount of oil.

This should only take a few minutes and will help ensure that your Ram’s engine runs smoothly for years to come.

2016 Dodge Ram 1500 Oil Filter Location

Where is the Oil Filter on a 2016 Dodge Ram 1500?

The oil filter on a 2016 Dodge Ram 1500 is located beneath the engine bay, close to the middle of your truck. To access it, you’ll need to lift up the hood and look for a black cylindrical piece with two hoses connected to it. This is your oil filter housing.

You will then want to loosen and remove its bolts using an appropriately sized wrench or socket set before carefully lifting out the old filter from its housing. After replacing it with a new one, make sure all connections are tight before closing up the hood and continuing with your journey!

Where is the Oil Filter on a 5.7 Dodge Ram 1500?

The oil filter on a 5.7 Dodge Ram 1500 is located in the engine bay, near the back of the engine, behind the alternator and power steering pump. It sits atop a round aluminum housing with two 10mm bolts securing it to the block. The filter itself is typically black or silver in color and has an attached rubber seal that helps keep any dirt or debris from entering into your engine.

To access it, you will need to unscrew these bolts and carefully remove the filter. Once removed, you should inspect it for any signs of damage or wear before cleaning off any excess dirt or grime with a shop cloth. After replacing it with a new one, be sure to securely tighten up those 10mm bolts so no contaminants can enter your engine’s oil system while driving down the road!

Where is the Oil Filter Located on a 2015 Dodge Ram 1500?

The oil filter on a 2015 Dodge Ram 1500 is located on the driver’s side of the engine, near the firewall. It is mounted directly to the engine block and can be accessed from beneath the hood. The filter itself is a metal canister that contains an internal paper element which filters out debris and contaminants from your motor oil.

To replace this filter, first you’ll need to make sure your truck is parked on level ground and has had time to cool off (as it may still be hot). Next, locate where the filter attaches to the engine block and use a wrench or socket set to loosen and remove it. Once removed, install your new oil filter in its place using clean gloves (to avoid touching any dirt) before replacing any oil that was lost during removal.

Finally, start up your vehicle again and check for any leaks around where you installed the new part before taking it back out onto roads!

Where is the Oil Filter on a 2014 Ram 1500 5.7 Hemi?

The oil filter on a 2014 Ram 1500 5.7 Hemi is located at the lower left corner of the engine, just above the oil pan. The filter can be accessed by removing a plastic cover that protects it from debris and moisture. When changing your vehicle’s oil, it is important to make sure you change out the old oil filter with a new one in order to keep your engine running smoothly and efficiently.

To ensure that you are replacing the correct part, make sure to reference your owner’s manual or consult an expert mechanic for assistance if necessary. Once you have replaced your old filter with a new one, carefully reattach the plastic cover and be sure to securely fasten all bolts before putting any additional pressure on them as this could cause further damage down the line.

Where is the Engine Oil Filter Located?

The engine oil filter is typically located in the bottom-right corner of your car’s engine. It is usually a cylindrical metal canister that rests on brackets or some other type of mount. The filter contains pleated paper and wire mesh screens which trap particles, debris and contaminants from the motor oil as it passes through, keeping them out of vital components within the engine.

The filter should be changed at least once every year or every 5,000 miles to ensure that it continues to function properly and keeps your engine running smoothly for many years to come.

2016 Ram 1500 Oil Filter Location


2016 Ram 1500 5.7 Oil Filter

The 2016 Ram 1500 5.7 is equipped with a Mopar oil filter that utilizes an advanced synthetic media to provide superior filtration and performance in extreme conditions. It features an anti-drainback valve that prevents oil from draining back into the engine during cold starts, as well as a silicone adhesive seal to ensure a tight fit and prevent leaks. This oil filter has been designed for optimal protection of your engine, helping it last longer and perform better over time.

2016 Ram 1500 Oil Capacity

The 2016 Ram 1500 has an oil capacity of 5.9 quarts when changing the engine oil and filter. This is slightly more than the previous year’s model, which had a capacity of 5.7 quarts. It is important to use the correct amount and type of motor oil for your particular vehicle in order to keep it running smoothly and efficiently for years to come.

2016 Ram 1500 Oil Reset

The 2016 Ram 1500 offers a convenient oil reset feature that allows the owner to easily reset the oil light after an oil change. This is done by simply pressing and holding the “Set/Reset” button on the dashboard for more than five seconds. After doing so, a message will appear confirming that the oil has been successfully reset.

This simple step can ensure your vehicle remains in top condition and help you keep up with regular maintenance.


In conclusion, knowing how to locate the oil filter in a 2016 Ram 1500 can be extremely beneficial for DIY mechanics. The knowledge of where to find it and what tools are necessary to change it will help save time and money. Additionally, with proper maintenance and upkeep, vehicle owners can ensure that their engine is functioning properly and safely.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *