The 2012 Ram 1500 has a fuel pump relay located in the power distribution center. This relay is responsible for supplying power to the fuel pump. If this relay fails, the fuel pump will not receive power and will not be able to operate.
If you’re looking for the fuel pump relay on your 2012 Ram 1500, it’s located in the engine bay, on the driver’s side. It’s a black box with a green lid, and it has “Fuel Pump Relay” written on it.
Installing a Dodge fuel pump relay bypass for a faulty TIPM repair
Where is the Fuel Pump Relay on 2011 Dodge Ram 1500?
The fuel pump relay on the 2011 Dodge Ram 1500 is located in the relay box near the fender well on the driver’s side. The relay box is usually located under the hood, but on some models it may be located in the trunk.
Where is the Fuel Pump Relay Switch Located?
The fuel pump relay is an important component of a vehicle’s electrical system. It is designed to switch the electric current to the fuel pump on and off as needed. The relay is usually located in the engine compartment, near the battery.
Where is the Fuel Pump Relay on a 2012 Dodge Durango?
Assuming you are referring to the fuel pump relay: The fuel pump relay on a 2012 Dodge Durango is located in the Totally Integrated Power Module (TIPM), which is in the engine compartment near the battery.
How Do I Know If My Fuel Pump Relay is Blown?
If your car isn’t starting, one possible cause could be a blown fuel pump relay. Here’s how you can check to see if your fuel pump relay is indeed the culprit.
First, check to see if there is power going to the fuel pump.
If there is no power, then the issue is almost certainly with the fuel pump relay. You can check this by using a multimeter to test for continuity between the two terminals on the bottom of the relay. If there is no continuity, then the relay needs to be replaced.
If there is power going to the fuel pump, then you’ll need to do some more diagnostics to figure out whether it’s the fuel pump itself or something else that’s causing the problem.
2012 Ram 3500 Fuel Pump Relay Location
If you’re looking for the fuel pump relay on your 2012 Ram 3500, it’s located in the engine compartment near the battery. It’s a black box with a white label that says “Fuel Pump Relay.” If you have any trouble finding it, consult your owner’s manual or a service manual for your truck.
2012 Ram Fuel Pump Relay Bypass
If your 2012 Ram has a fuel pump relay bypass, it means that the fuel pump will continue to operate even if the engine is turned off. This can be a useful feature if you need to keep your fuel tank full while you’re away from home, or if you want to avoid having to restart your engine after refueling.
However, there are some potential drawbacks to using a fuel pump relay bypass.
First, it’s important to make sure that you don’t accidentally leave your engine running when you turn off the ignition. If you do, you could waste a lot of gas and potentially damage your engine. Second, if your battery dies while your engine is off, the fuel pump will continue to run and drain your battery.
This could leave you stranded without power. Overall, a fuel pump relay bypass can be a helpful feature, but it’s important to use it wisely and understand the potential risks involved.
2012 Ram 1500 Fuel Pump Relay Recall
As of October 23, 2012, Chrysler has issued a recall for certain model year 2012 Ram 1500 trucks. The recall affects approximately 4,200 vehicles.
The recall is due to a problem with the fuel pump relay.
In affected vehicles, the fuel pump relay may fail and cause the engine to stall without warning. This can increase the risk of a crash. Chrysler will notify owners of affected vehicles and dealers will replace the fuel pump relay free of charge.
The recall is expected to begin on November 16, 2012. Owners may contact Chrysler customer service at 1-800-853-1403.
The 2012 Ram 1500 has a fuel pump relay located in the Power Distribution Center. The Power Distribution Center is located in the engine compartment on the driver’s side of the vehicle. The fuel pump relay is labeled “FPR” and is located in the bottom row of relays.
You Can Read Also: