Ram 2500 Gear Ratio Chart
If you’re looking for a Ram 2500 Gear Ratio Chart, we’ve got you covered. Here’s everything you need to know about choosing the right gear ratio for your Ram 2500. Whether you’re looking for better fuel economy, towing power, or just want to make your truck look good, we’ll help you figure out which gear ratio is right for you.
The Ram 2500 is a heavy duty truck that was first introduced in 1994. It’s available in both two-wheel and four-wheel drive configurations, and can be had with either a gas or diesel engine. The Ram 2500 is built on a chassis that’s shared with the Ram 1500, but it’s longer and has a higher payload capacity.
When properly equipped, the Ram 2500 can tow up to 17,980 pounds.
One of the most important things to consider when shopping for a new truck is the gear ratio. The gear ratio determines how much torque is sent to the wheels and how fast the vehicle can accelerate.
If you’re looking for a truck that can tow heavy loads or do a lot of off-roading, you’ll want a truck with a low gear ratio. A lower gear ratio means there’s more torque being sent to the wheels, which is ideal for towing and off-roading. But if you’re mostly going to be driving on the highway, you’ll want a truck with a higher gear ratio so it can cruise at high speeds without putting stress on the engine.
Not sure what gear ratio you should get in your Ram 2500? Check out this handy chart:
Gas Engine
2WD 4WD
Regular Cab Long Bed 3.21 3.55 N/A
Regular Cab Short Bed 3.21 3.55 N/A
Crew Cab Long Bed 3.42 3.73 N/A
Crew Cab Short Bed 3:42 3:73 N/A
Diesel Engine
2WD 4WD
Regular Cab Long Bed 4:10 4:30 4:10
Regular Cab Short Bed 4:10 4::30 4::30
Crew Cab Long Bed 4::36 4::44 4::36
As you can see from the chart above, there are different gear ratios depending on which model of Ram 2500 you have and whether it has a gas or diesel engine.. And while there are some slight variations between 2WD and 4WD models, generally speaking, trucks with shorter beds will have slightly higher ratios than those with longer beds.. So if you’re looking for ultimate towing power or serious off-road capability, go for a regular cab long bed model with either gas or diesel power.. But if highway cruising is more your thing, any of the other models will do just fine.. Just remember to keep an eye on your payload capacity so you don’t overload your truck!
You Must Get 4.10 Gears – Ram 2500 5th gen 2021
What is the Best Gear Ratio for a Ram 2500?
There is no definitive answer when it comes to choosing the best gear ratio for a Ram 2500, as it depends on a variety of factors such as how the truck will be used, what kind of terrain it will be driven on and what sort of payloads it will be carrying. However, there are some general guidelines that can be followed in order to choose a gear ratio that will suit your needs.
If you plan on using your Ram 2500 for off-road driving or towing heavy loads, then a lower gear ratio would be ideal in order to provide more torque.
On the other hand, if you mostly drive on highways or city streets, then a higher gear ratio would be better suited as it would result in better fuel economy. Ultimately, it is important to consider all of these factors before making a decision so that you can choose the best gear ratio for your specific needs.
How Do I Find Out What Gear Ratio My Ram 2500 Has?
If you’re not sure what gear ratio your Ram 2500 has, there are a few ways to find out. First, you can check the build sheet or window sticker that came with the truck when it was new. This will list all of the specs for the truck, including the gear ratio.
Another way to find out is to look at the doorjamb sticker. This sticker will also list the gear ratio, as well as other important information about the truck.
Finally, you can always contact a Ram dealership and they should be able to tell you what gear ratio your truck has.
What Gear Ratio is Best for Towing?
Towing capacity is a measure of how much weight your vehicle can tow. The gear ratio is the number of teeth on the ring gear divided by the number of teeth on the pinion gear. A higher gear ratio means more torque and a lower gear ratio means less torque.
For towing, you want a lower gear ratio so that your engine doesn’t have to work as hard. A lower gear ratio also means that your vehicle will be slower on the highway, but this is not necessarily a bad thing when you’re towing a heavy load.
The best gear ratio for towing will depend on the weight of your trailer and the power of your engine.
If you have a powerful engine, you can get away with a highergear ratio because your engine will be able to handle the extra load. However, if you have a weaker engine or are towing a very heavy trailer, you’ll want to go with a lower gear ratio so that your engine isn’t overloaded.
Experiment with different gear ratios until you find one that gives you good power without overworking your engine.
And always consult your owner’s manual before making any changes to ensure that you’re not exceeding the capabilities of your vehicle.
What Gear Ratio is in My Dodge Ram?
There are a few different ways to figure out what gear ratio is in your Dodge Ram. One way is to look at the door sticker or build sheet. This will usually have the gear ratio listed somewhere on it.
Another way is to jack up the truck, put it in neutral, and spin one of the wheels while counting how many times the driveshaft turns. For example, if it takes four rotations of the driveshaft to turn the wheel once, then you have a 4:1 gear ratio.
Credit: www.4x4offroads.com
2022 Ram 2500 Gear Ratio
The Ram 2500 is a workhorse of a truck, and it’s got the numbers to back it up. With a max towing capacity of 19,780 pounds and a payload capacity of 4,040 pounds, this thing can haul just about anything you need it to. But what’s really impressive is the Ram 2500’s gear ratio.
With a 6.4-liter V8 engine under the hood, the Ram 2500 has a best-in-class gas torque rating of 429 lb.-ft. That kind of power demands some serious gears, and that’s exactly what you’ll find in the Ram 2500.
It comes standard with 4.10 gears, but if you opt for the available 6.4-liter Hemi V8 engine, you’ll get an even beefier 4.30 gear ratio.
Whether you’re hauling heavy loads or just cruising down the highway, that kind of gearing helps your truck run more efficiently by keeping the engine in its sweet spot. And when you’re ready to tackle some serious off-roading, those low gears come in handy for crawling over obstacles without getting bogged down.
Ram Gear Ratio by Vin
If you’re a truck owner, then you know that your Ram truck’s gear ratio is an important piece of information. Your gear ratio affects how your truck performs under a load, and it also impacts your fuel economy. So what exactly is gear ratio and how does it work?
Let’s take a closer look.
Gear ratio is the number of teeth on the driven gear (the one that’s connected to the driveshaft) divided by the number of teeth on the drive gear (the one connected to the engine). The higher the gear ratio, the more torque is required to turn the driven gear.
That means that when you’re carrying a heavy load or pulling a trailer, a higher gear ratio will give you better performance. However, it also means that your engine has to work harder, which can impact your fuel economy.
To find out what gears are in your Ram truck, just look at the doorjamb sticker – it’ll list both the axle code and the final drive ratio.
The most common ratios for light-duty Ram trucks are 3.21:1 and 3.55:1; for heavy-duty trucks, you’ll see ratios like 4.10:1 and 4.56:1.
Knowing your Ram truck’s gear ratio can help you make informed decisions about how to use your truck and what kinds of loads or trailers it can handle best. It’s an important piece of information for any serious truck owner!
Dodge Ram 2500 Axle Specs
When it comes to full-size trucks, the Ram 2500 is in a class of its own. With its incredible towing and hauling capabilities, the Ram 2500 is the perfect truck for those who need a vehicle that can handle any job. But what makes the Ram 2500 so special?
Part of it has to do with its axle specs.
The Ram 2500 comes standard with a Dana 60 front axle and a Dana 70 rear axle. These axles are incredibly strong and allow the Ram 2500 to tow up to 17,980 pounds (when properly equipped).
The Dana 60 front axle is also equipped with an electronic locking differential, which allows you to tackle any terrain, no matter how tough.
Whether you’re looking for a truck that can handle the toughest jobs or you simply need a reliable vehicle for your daily commute, the Ram 2500 is the perfect choice. With its strong axles and powerful engine options, the Ram 2500 will get you where you need to go – no matter what.
Conclusion
The Ram 2500 is a full-size pickup truck that was introduced in 1994. It is available in three different cab styles and four different bed lengths. The Ram 2500 has a maximum towing capacity of 19,780 pounds and a maximum payload capacity of 3,990 pounds.
It is powered by a 5.7-liter V8 engine that produces 383 horsepower and 400 lb-ft of torque. The Ram 2500 is equipped with a six-speed automatic transmission and has a fuel economy rating of 17 mpg in the city and 21 mpg on the highway.
