Recommended Coolant for 2013 6.7 Cummins: Top Picks & Tips
Finding the right coolant for your 2013 6.7 Cummins engine can be tricky. The right choice…

Finding the right coolant for your 2013 6.7 Cummins engine can be tricky. The right choice…

Resetting a battery current sensor is essential for accurate readings. This task can seem complex, but…

Dodge Ram wheel speed sensor problems can be frustrating and troublesome. These issues can affect your…

The Ram 2500 is a beast on the road. But what metal is it made from,…

The normal oil pressure at idle for a 5.7 Hemi engine ranges from 20 to 40-42…

The 5.7 Hemi Tick at idle is a common issue caused by failed lifter hydraulics and…

Experiencing low oil pressure at idle could be a result of system leaks, low oil levels,…

The variable valve timing solenoid on a 5.7 Hemi engine is located underneath the intake manifold….

The Dodge 4.7 MAP sensor is usually located on the intake manifold. Introduction To The Dodge…

The oil pressure relief valve is located at the oil pump outlet, and its purpose is…

The Cummins ISX fuel pump actuator is located on the back of the injection pump, on…

The Cummins air intake heater relay is located in the engine compartment, specifically in the cavity…

The Cummins ISX fuel check valve is located inside the fuel housing where the lift pump…

The Cummins Injector Metering Rail 1 Pressure Sensor is located in the high pressure fuel rail….

The Cummins 6.7 intake manifold pressure sensor is located on the driver’s side of the intake…

The 6.7 Cummins may experience rough idle at startup due to various factors such as dirty…

The oil pressure sensor on the Cummins L9 engine is located on the left side, under…

The 6.7 Cummins fuel control actuator is located on the side of the high-pressure fuel injection…

The crankshaft position sensor on the Cummins ISC 8.3 engine is located on the backside of…

The coolant temperature sensor on a 12 Valve Cummins engine is located in the front right…

The Cummins N14 engine serial number can be found on the engine rocker cover or on…

The Cummins ISX15 aftertreatment purge air actuator is located above the shutoff valve manifold. It may…

The 6.7 Cummins engine may produce a squealing noise at idle due to a worn or…

The exhaust gas pressure sensor on a Cummins ISX engine is located above the front section…

The Cummins ISX turbo speed sensor is located on the high pressure pipe after the turbo,…

The Cummins ISX Aftertreatment Fuel Shut Off Valve is located on the driver’s side of the…

The oil cooler on a Cummins ISX engine is located in the front of the engine,…

A 6.7 Cummins surging at idle may be caused by a faulty fuel pump actuator. Other…

The Cummins ISX crankshaft position sensor is typically located on the top of the flywheel housing….

The exhaust brake on a 6.7 Cummins is located on the driver’s side of the engine,…

The fuel water separator on a 6.7 Cummins engine is located under the seat on the…

The oil control valve on a 5.7 Hemi engine is located under the intake manifold. There…

The Transmission Control Module (TCM) on a 6.7 Cummins is located within the Engine Control Module…

The Cummins ISX throttle position sensor is located on the accelerator pedal. Symptoms of a failing…

The idle adjustment for a 12 Valve Cummins can be done by turning the idle screw…

The Cummins ISB oil pressure sensor is located on the outside of the engine block, in…

The Cummins X15 oil thermostat is located in the front of the engine. The Cummins X15…

The “6.7 Cummins Exhaust System Service Required See Dealer Now” message on your vehicle indicates a…

The most common cause of a coolant leak on the passenger side of a 6.7 Cummins…

The grid heater on a Cummins diesel engine is located directly between the air horn and…

The Cummins Isl9 crankcase pressure sensor is located on the left side of the engine, on…

The Cummins ISX EGR sensor is located on the top of the EGR valve, close to…

The oil pressure sensor for a Cummins N14 Celect Plus is located on the engine block…

The normal oil pressure for a Cummins ISX at idle should be between 15-40 PSI. If…

The fuse for the 6.7 Cummins exhaust brake is located behind the battery and is labeled…

The exhaust gas temperature sensor on a 6.7 Cummins engine is typically located around the turbocharger,…

The Cummins ISX fuel lift pump relay location can be found near the fuse box and…

The oil temperature sensor for a 6.7 Cummins engine is located in the side of the…

The Cummins ISX fuel priming pump is located on the filter housing and is ECM controlled….

The fuel rail pressure at idle for a 6.7 Cummins engine should be within the normal…